E30 Zone

Got a stainless exhaust to go on my car but its got stupid DTM? upswept tailpipes on it.
I would like to hack these off and weld some nice subtle straight exit ones on in place.
Anyone know of anywhere online that does these?

Could you not just cut off from where they sweep up

I've seen it done before

ImysE30 wrote:Could you not just cut off from where they sweep up

I've seen it done before

Yes but they be an inch or so too short

Get some same size tubing and weld it yourself or get a mate?

6potpower wrote:Get some same size tubing and weld it yourself or get a mate?

Tubing is good idea but id rather something that has a decent tip choice to look at.
Mate who is a tig welder is on hand to weld them for me.

Dont you like the blue fade tip thing if you get me

I dont know if u have a longlife.co.uk near u ?? there good for this sort of thing

if not they have loads of different style tail pipes to give u a idea

6potpower wrote:Dont you like the blue fade tip thing if you get me

EH?

Neil I did think about nipping in one of thosde Longlife places to see if they would sell me some.Think I will do that at some point this week

Uno the rudeboy one

6potpower wrote:Uno the rudeboy one

Not for me im afraid

Damm would of been easy to make like it look like its oem with the zaust

eko wrote: Neil I did think about nipping in one of thosde Longlife places to see if they would sell me some.Think I will do that at some point this week

just a thought

Im going to longlife later on this week to get my dual back box made for my xtrail