Page 1 of 1
Is it possible from aluminium to Plastic?
Posted: Tue Jul 26, 2005 3:39 am
by ndibari
Friends, I need urgently your help,
I have a bmw 325 and of the year 1985 aluminium bumpers, and want to install the kit m technik the II, it is possible? Front and rear, even the border front of the front bumper.
Someone knows where I can obtain information brings over of since the conversion does???
Please I need your help rapidly Ԛ¡
Thank youԚ¡
ndibari
Chile.
Posted: Tue Jul 26, 2005 10:28 am
by johnono
hello ndibari
welcome to the zone
,
hate to be the bringer of bad news, but the side panels will not fit yours without adjustment, as the hight of the rear arch is different than that of the phase 2, for which it was intended
although, on the bright side, you can easily fit the front and rear bumpers and lower parts also
, but the new mtecs must have the facelift internals attatched, inside or it will be a pain to convert them to
good luck fella, and hope u like the Zone
Posted: Tue Jul 26, 2005 8:04 pm
by M155-E30
ive done the same, i had a 86 chrome bumper 325, i got an mtec kit from
www.autotintdesign.com, not bad price but did take alot of work.. def need someone who knows what they are doin..
Posted: Wed Jul 27, 2005 5:20 am
by aussie_e30
apparantly the m-tech II kit fits a pre-facelift cab better. but I assume you don't have the cab.
i've been looking into this too, there is a good guide over at:
http://www.r3vlimited.com/Tech/bumper1.htm
THANKS FRIENDS¡¡¡¡¡Ã
Posted: Thu Jul 28, 2005 3:43 am
by ndibari
I HAVE THE SIDE M TECH 2 FOR THE FOUR DOOR CAR.
MY CAR 325E OF 1985 IS A CAR OF FOUR DOORS, I HOPE THIS SIDE KIT FIT IN MY CARԚ¡Ã”šÃ‚¡Ãƒ”šÃ‚¡Ãƒ”šÃ‚¡Ãƒ”šÃ‚¡Ãƒ”šÃ‚¡Ãƒ”šÃ‚¡Ãƒ”šÃ‚¡ I WANNA CRYYY
REALLY I DONT PROBE IS THIS SIDE KIT FIT IN MY FOUR DOOR CAR. I REALLY WANNA DIE.
THANKS A LOT FOR THE SITES, REALLY HELP ME IN MY FITMENT OF THIS KIT
I REALLY A LOT A IDEAS AND PICS AND ALL FOR FINISH MY PROJECT.
THANKS AGAIN TO THE SOUTH OF THE WORLD.
NDIBARI