Page 1 of 1
M50 Help !
Posted: Thu Jun 14, 2007 11:18 pm
by m-dtech
Final few teathing problems.....
can anyone help with this ?
where do these bits go to/ from ?
Re: M50 Help !
Posted: Thu Jun 14, 2007 11:21 pm
by maxfield
S50
S50 is ITB'ed and is a much different intake to this.
Re: M50 Help !
Posted: Thu Jun 14, 2007 11:26 pm
by m-dtech
maxfield wrote:S50
S50 is ITB'ed and is a much different intake to this.
yeh thats my bad its actualy an S52 but has nothing to do with my question.
Re: M50 Help !
Posted: Thu Jun 14, 2007 11:28 pm
by 320Touring
maxfield wrote:S50
S50 is ITB'ed and is a much different intake to this.
think you find its just a pic he found on the net.
Has highlighted the m50 pieces he's enquiring about.
simple really!
Mike, I have no clue
Re: M50 Help !
Posted: Thu Jun 14, 2007 11:32 pm
by maxfield
Ah ok, seemed as though you were comparing them. My bad.
Re: M50 Help !
Posted: Thu Jun 14, 2007 11:35 pm
by m-dtech
maxfield wrote:Ah ok, seemed as though you were comparing them. My bad.
lol give me strength.
Re: M50 Help !
Posted: Thu Jun 14, 2007 11:36 pm
by old_skool
Pure guess:
Middle circle is the idle control valve connection, top circle is the temp sensor pocket. Pure guesswork you'll have to understand
Re: M50 Help !
Posted: Thu Jun 14, 2007 11:38 pm
by m-dtech
top is a connection of some sort the air temp sensor is to the right of it
the connection on the ICV inlet is a vac line but i dont know where it goes.
Re: M50 Help !
Posted: Thu Jun 14, 2007 11:41 pm
by old_skool
Is that top one a vacuum line for the servo?
Re: M50 Help !
Posted: Thu Jun 14, 2007 11:43 pm
by m-dtech
servo goes into another part of the inlet
Re: M50 Help !
Posted: Sat Jun 16, 2007 4:07 pm
by Gabi_323i
this is very simple, the "top" of the picture shows the vacuum port for the fuel pressure regulator
and the other one to the crankcase ventilation fitting on the front left side (passanger side for you UK guys) on the engine cover (camshafts cover)