Page 1 of 1
M50 head / M54 block
Posted: Thu May 03, 2007 1:21 pm
by alexbaby88
Will a M50B25 head fit on a M54B30 block?
Posted: Sun May 06, 2007 7:57 pm
by dasparkybad
sorry dude they are very different
Posted: Tue May 08, 2007 5:12 pm
by alexbaby88
Then will M54B30 crank, rods and pistons fit directly into the M50? This theoretically should give a Bore / stroke of 84mm/89.6mm the same as M54B30. ie iron block 3.0L?
Re:
Posted: Tue Aug 21, 2007 11:56 pm
by gorgeee
id like to know the same but if a M54b28 cranks and rods and pistons fit a m50b25
Re:
Posted: Wed Aug 22, 2007 7:32 pm
by jaistanley
You could always track down an american M3 3.0 or 3.0 crank rods and pistons and have them shipped over.
I have heard tale that you can use the M54 stuff but have no further details. Try the american forums such as E30Tech, they're always trying to cram more displacement from the M50.
Jai
Re:
Posted: Thu Aug 23, 2007 3:20 am
by gorgeee
thanks mate
Posted: Fri May 28, 2010 7:26 am
by alexbaby88
alexbaby88 wrote:Then will M54B30 crank, rods and pistons fit directly into the M50? This theoretically should give a Bore / stroke of 84mm/89.6mm the same as M54B30. ie iron block 3.0L?
The M54 rotating bits are a direct drop in to a M50/M52 block. Easy way to get to 3.0L.