Page 1 of 1
my DIY refurbed Alloys
Posted: Sat Jun 20, 2009 5:35 pm
by e30_fletch
Re: my DIY refurbed Alloys
Posted: Sat Jun 20, 2009 5:57 pm
by e30_fletch
And my slightly updated front end
i know e30 purists will realise tht the splitter is from a mk3 golf vr6 but i think it reli looks the part on here
Re: my DIY refurbed Alloys
Posted: Sat Jun 20, 2009 6:02 pm
by cracker
Are the wheels momo GT2's?
nice work.
Re: my DIY refurbed Alloys
Posted: Sat Jun 20, 2009 6:17 pm
by e30_fletch
yea they are
Re: my DIY refurbed Alloys
Posted: Sat Jun 20, 2009 6:19 pm
by ImysE30
Nice job, looks very
Re: my DIY refurbed Alloys
Posted: Sat Jun 20, 2009 8:21 pm
by capri_rob
Nice work fella - but I hope there's no speed-bumps near you or that front splitter won't be there long
Re: my DIY refurbed Alloys
Posted: Sat Jun 20, 2009 8:32 pm
by harry_p
Splitter looks better than I would have though, but would be better if it replaced the standard lip rather than sitting under it.
Re: my DIY refurbed Alloys
Posted: Sat Jun 20, 2009 9:23 pm
by Rav335uk
I was wondering if your taking off the small splitter, then putting the vw one on
Re: my DIY refurbed Alloys
Posted: Sat Jun 20, 2009 11:07 pm
by e30_fletch
i will be eventually but haven`t got 2 it yet as i have 2 M.O.T it first before i do anymore mods but i`m wondering if any1 has any ideas on other mods i can do 2 the front
Re: my DIY refurbed Alloys
Posted: Sat Jun 20, 2009 11:21 pm
by Cloggy Saint
Sort out the rusty wing/door?
Re: my DIY refurbed Alloys
Posted: Sun Jun 21, 2009 8:03 am
by e30_fletch
yes its on my list of repairs 2 do
Re: my DIY refurbed Alloys
Posted: Sun Jun 21, 2009 8:29 am
by shedrool83
Great work they look good
Re: my DIY refurbed Alloys
Posted: Sun Jun 21, 2009 1:54 pm
by e30_fletch
Got up early this mornin to put them back on finally comments please
Re: my DIY refurbed Alloys
Posted: Sun Jun 21, 2009 5:42 pm
by greentouring
Good work! The yellow works well to break up the blackness.
Re: my DIY refurbed Alloys
Posted: Sun Jun 21, 2009 8:26 pm
by SLIMADI
Looks sweet i keep meaning to do my rims one day top job fella
Re: my DIY refurbed Alloys
Posted: Sun Jun 21, 2009 8:32 pm
by Ziggy
Looks like they're a FWD offset? Would look better spaced out a bit...
Re: my DIY refurbed Alloys
Posted: Mon Jun 22, 2009 1:43 am
by e30_fletch
i dunno i bought them from a guy who had them on his 324d i was thinkin 10mm front 20mm rear
Re: my DIY refurbed Alloys
Posted: Mon Jun 22, 2009 12:12 pm
by Baz666
looks good fella...smoke your front lights.
