It wasn't immaculate by any stretch of the imagination and had seen some armco at some point, but it was exactly what I was after and the price was keen enough. But then there was the problem of this being my first RWD car, in February, on Dunlop Direzzas and it wasn't long (little over a week infact

It was being done as a homer, so I only took delivery of it back today and I can get down to the job of putting back together. The wiring is a complete mess and I'll no doubt be asking loads of stupid questions, but I'm looking forward to getting her running again as soon as possible

Here are some photos then:

Where the hell do all these wires go? (BTW: duct tape isn't going to be holding the whole thing together.)
