Head Gasket
Posted: Sun Jan 20, 2008 6:11 pm
Can some one tell me the correct torx settings for the head bolts?
On a 325i
Cheers Steve
On a 325i
Cheers Steve
Page 1 of 1
Re: Head Gasket
Posted: Sun Jan 20, 2008 8:04 pm
I could do with this info as well as the Haynes and Autodata books have different figures.
Re: Head Gasket
Posted: Sun Jan 20, 2008 9:44 pm
This differs between the old style hex bolts (which you shouldnt be using now) and the spline heads. I'll check the bentley manual and post back unless someone gets there first.
Re: Head Gasket
Posted: Mon Jan 21, 2008 1:10 pm
Bentley quotes for torx bolts; 1 ,22ft.lb. 2, 90degree torque angle. 3,90degree torque angle.For hex bolts;30 ft.lb,wait 15 min then 44ft.lb,then with engine at operating temp 25 degree torque angle.
Re: Head Gasket
Posted: Mon Jan 21, 2008 5:39 pm
cheers for that me8
hop to get my head back for the weekend
so with a bit of luk be on the road buy monday
then it on to the interior and little body work
and she will look as good as new
hop to get my head back for the weekend
so with a bit of luk be on the road buy monday
then it on to the interior and little body work
and she will look as good as new