E30 Zone

Posted: **Fri Jan 18, 2008 4:46 pm**

How the hell do I retro fit the control panel cover? Do I have to strip/cut away the front part of the roof lining?
cheers
Paul

Posted: **Fri Jan 18, 2008 5:19 pm**

No, have you looked at it yet?

Posted: **Fri Jan 18, 2008 6:47 pm**

yes i had a wee mess with it but it seemed to fit abit to proud. the car it came off had a bit of roof lining missing where it goes mate so sorta guessed mine would have to be the same

Posted: **Fri Jan 18, 2008 11:34 pm**

Posted: **Fri Jan 18, 2008 11:55 pm**

Both of my e30's with check control still had the full headlining but with the black moulding over the top, both left the factory like this.

Cheers,

Iain T

Posted: **Sat Jan 19, 2008 12:34 am**

Hello, there should be two (o/s &n/s) screw fixings on the panel you want to fit, they secure from the inner sunroof gutter. Then you should have a lip that folds over the roof lining lip under o/s & n/s door sills also lips around roof lining around sunroof. If the screw fixings are missing on the panel, then i am affraid it will never fit correct and no you do not have to cut the roof lining. Thank you

Posted: **Mon Jan 21, 2008 9:45 pm**

Ta very much mate

E30 Zone

Check panel cover, the bit that holds the sunvisers etc

Check panel cover, the bit that holds the sunvisers etc

Re: Check panel cover, the bit that holds the sunvisers etc

Re: Check panel cover, the bit that holds the sunvisers etc

Re:

Re:

Re: