Page 1 of 1
noisy m10
Posted: Fri Jan 11, 2008 10:06 pm
by retroroy
does anyone no about m10 engines i have a 316 pre injection when its cold it sounds sweet but when warm its very tapy and seems to hunt as well also what can you do to get more power out of them thanks
Re: noisy m10
Posted: Fri Jan 11, 2008 10:10 pm
by Alex
if its hunting it usually means the carb it shot, the pierburg carbs on them are terrible and best to be fitted with a weber replacement carb, just baught one for mine they just bolt straight on and do away with all the electric stuff which the pierburg has on making it less troublesome
if its tappty you might have to adjust your tappets

Re: noisy m10
Posted: Fri Jan 11, 2008 10:15 pm
by retroroy
were would i find one of these carbs also if the carb is shot would it drink fuel mine is very very bad on fuel thanks
Re: noisy m10
Posted: Fri Jan 11, 2008 10:21 pm
by Alex
might be the case but there not very economical anyway the weber replacement should improve economy you could try ebay but your best bet is to start a thread in the wanted section on here thats where i got mine it cost me £25 the only downside with it is you need a manual choke

Re: noisy m10
Posted: Fri Jan 11, 2008 10:24 pm
by lance1a
Hi, You can use a carb from a VW Golf/jetta etc 1.8 (as long as it's the weber one). The Pierburgs are rubbish.
Adjusting the tappets is easy if you have three hands and know how. Though it usually takes a few times to work out how to do it properly. Haynes manual describes how. Weber 32/36 DGV upgrade is good for a few extra ponies. But standard you should be getting about 28/30MPG so don't expect it to get any better:D
Re: noisy m10
Posted: Fri Jan 11, 2008 10:28 pm
by retroroy
thanks for your help i will look in to it
Re: noisy m10
Posted: Fri Jan 11, 2008 10:30 pm
by Alex
no probs

Posted: Sat Jan 12, 2008 4:41 pm
by rvrboy
Your timing chain or tensioner might be making a lot of your noise.
Cheers gerry