Page 1 of 1

adjust head lamp aim

Posted: Thu Aug 02, 2007 11:17 am
by hossy
any one know how to adjust the headlamp aim mine are too low and its got the switch on the dash to do it but they dont move checked fuse but non are gone is there a manual way of doing it,the nasty man at the mot station failed it on that and told me i got to sort it.

Re: adjust head lamp aim

Posted: Thu Aug 02, 2007 11:24 am
by smithy318i
The headlight adjustment inside the car is hydraulic and 99% of owners cars are fooked. You can manualy adjust the level by rotating the knurled section of the black cylinder on the headlight assembly.

Re: adjust head lamp aim

Posted: Thu Aug 02, 2007 1:04 pm
by siddiqi1
This might help, has been covered before, i need to do mine too

If you dont mind, after youve done it, can you inform me whether its a job forthe emch or a DIY'er

Click here for thread

Regards

Saboor

Re: adjust head lamp aim

Posted: Tue Sep 25, 2007 9:44 pm
by hossy
hey up i did what was said manually and the lights did go up and down but when i took it for mot they still said they were too low.but luckly they let it pass

Re: adjust head lamp aim

Posted: Tue Sep 25, 2007 9:56 pm
by siddiqi1
oh ok,going to atempt that then this weekend!

Re: adjust head lamp aim

Posted: Tue Sep 25, 2007 10:05 pm
by Brianmoooore
There is a preset adjustment in middle of the defective hydraulic adjusters as well, in the form of the threaded steel rod that goes out the front of the cylinder. This has a Philips screw recess in the ball at the headlamp end to turn it, which can't be accessed without removing the headlamp, but you can usually turn it with a pair of small grips.
The screw needs to be screwed outwards (longer) a few turns to bring the aim up, then fine adjust it with the outer barrel of the hydraulic cylinder.