Page 1 of 1
Diff question...
Posted: Sun Apr 22, 2007 10:59 am
by Giggz
Hope someone can shed some light on this...
Ok heres my diff (LSD).

I was going over it with one of those wire brushes and decided to do the same to the underneath of the diff so i turned it over and found a puddle of oil coming from here...

Should there be a little hole in this tube like thing or have i diturbed something i shouldnt have?
Re: Diff question...
Posted: Sun Apr 22, 2007 11:01 am
by zaust
Breather of sort... Don't worry..
Re: Diff question...
Posted: Sun Apr 22, 2007 11:01 am
by E30Mark
It's the breather, it is meant to have a hole in it, don't worry!!!
Posted: Sun Apr 22, 2007 11:08 am
by Giggz
PHEW!! Thanks guys.
So if i was to say wrap some tape around it this time...flip it over and continue to clean it it would be ok?
Re:
Posted: Sun Apr 22, 2007 11:15 am
by E30Mark
Yep

Posted: Sun Apr 22, 2007 11:28 am
by Giggz
Cheers Mark.

Re:
Posted: Sun Apr 22, 2007 11:43 am
by carlos_320i
How much did you loose as you might need to top it back up again
Posted: Sun Apr 22, 2007 12:52 pm
by Giggz
It was not alot to be honest has i only had it upside down for about 20 seconds but in saying that would it be worth draining the lot and do a oil change?
Re:
Posted: Sun Apr 22, 2007 1:28 pm
by glenbat
If you do i guess you can do it off car, i been advised to loosen the top plug first (when in situ) just in case you get the bottom drain plug out, then the top fill plug rounds off = new diff/lots of tears
