Page 1 of 1

How to remove a Cabrio door window - Anyone know?

Posted: Thu Mar 08, 2007 11:08 am
by Z3I
I need to remove the window glass from my cabrio door. Anyone know how? Seems like the runner pictured is holding it in?

Thanks


Image

Re: How to remove a Cabrio door window - Anyone know?

Posted: Thu Mar 08, 2007 11:19 am
by kamyk
hiya mate taking the window out is not too hard but puting it back in is very hard lol..

take off your door card then basically u got ten mill nuts bolts and a few ten mill nnuts wat to do is open all of them and then u will have one nut on the motor looen that as much as u can get somebody to hold the window and wind it up or down and the runners willcome out

hope this helps

Re: How to remove a Cabrio door window - Anyone know?

Posted: Thu Mar 08, 2007 7:37 pm
by Z3I
Ooo..where are these nuts, on the mech itself?

Re: How to remove a Cabrio door window - Anyone know?

Posted: Thu Mar 08, 2007 7:45 pm
by Chris-W
If you unbolt the window regulator mechanism from the door you'll be able to slip it off the window mounts.

Re: How to remove a Cabrio door window - Anyone know?

Posted: Fri Mar 16, 2007 10:49 am
by dj_raoul
@Z3I, did you succeed? Which method did you use?

@Chris-W, do you mean the slider in the middle of this picture will slip out of the rail attached to the window?


I need to get the window out too, to replace the window guide rail in the rear of the door :(

Re: How to remove a Cabrio door window - Anyone know?

Posted: Fri Mar 16, 2007 12:51 pm
by Z3I
I'm just about to retry this weekend. must admit, I thought I had loosened everything so far,I'm still not really clear.

Re: How to remove a Cabrio door window - Anyone know?

Posted: Fri Mar 16, 2007 2:33 pm
by Brianmoooore
Chris-W wrote:If you unbolt the window regulator mechanism from the door you'll be able to slip it off the window mounts.
--------------------------------------------------------------------------------

hiya mate taking the window out is not too hard but puting it back in is very hard lol..

take off your door card then basically u got ten mill nuts bolts and a few ten mill nnuts wat to do is open all of them and then u will have one nut on the motor looen that as much as u can get somebody to hold the window and wind it up or down and the runners willcome out

I think that is what this says, Chris!

Re: How to remove a Cabrio door window - Anyone know?

Posted: Sun Mar 18, 2007 5:28 pm
by Z3I
Yep, worked like a treat. i undid the 3 bolts, and 2 nuts, moved the mech around inside the door, and the wheels slipped out of the guides. Window out ok!

Now after messing with the central locking I'll have a go at putting it back together.

Re: How to remove a Cabrio door window - Anyone know?

Posted: Sun Mar 18, 2007 11:20 pm
by dj_raoul
Yep, worked fine for me too... Putting it back in wasn't so hard either, especially since I had an extra pair of hands helping me (doing it alone will be more difficult I think...)