E30 Zone

i have a clifford concept 600 alarm which was fitted to one of my previous cars i want to fit it to my current car

i have a clifford concept 300 on one of my other cars

i want to connect mine the same way so when the alarm is on you turn the key and it doesnt get power untill you turn the alarm off

how do i do this?

i also have 2 meta security window modules that were in the car when i brought it they are all wired up but i was wondering if i can connect these to my clifford alarm?

i know ur need the clifford module to make the windows roll up

doesnt the clifford alarm have a output that can work with any window module i thought it was just a signal to close windows once the alarm has turned on

yeah it is just a signal you can either use a neg when armed output from the 600, or you can use one of the aux outputs too so when you activate aux you can put the windows up without activating the alarm. if you want the distructions i can e mail them to you, just confirm what alarm you have.

kam

how can i have the above setting on my clifford concept 600 so that when the alarm is on and if you insert the key into the ignition it wont have any power there at all no even to turn the headunit on when you turn the alarm off it comes on

can the alarm work without the wireless fuelgard i think i left this in the other car

i am confuzzled!!!

mate i personally would not mess with any alarm system myself, prefer to get an expert fit it, Clifford like all other alrams are olny as good as the fitter fitting it.

I've known too many cars that have fucked up after "non-qualified" people start fitting them.