need help 2.8 z3 conversion
Posted: Wed Nov 29, 2006 11:23 am
hi people i need help!!!!
thinking of putting a z3 2.8 mulivalve engine into an e30 with carbs
what will i need to complete this project.
i have complete front and rear axles
complete engine and box
also engine mounts
and i know some guys up north who can make up a inlet manifold.
i can get my hands on a wiring loom too.
but dont know how to go about with the carbs.
please help
thanks hass
thinking of putting a z3 2.8 mulivalve engine into an e30 with carbs
what will i need to complete this project.
i have complete front and rear axles
complete engine and box
also engine mounts
and i know some guys up north who can make up a inlet manifold.
i can get my hands on a wiring loom too.
but dont know how to go about with the carbs.
please help
thanks hass
look through engine mods lots of good info and a lots of knowledge about engine conversions 