E30 Zone

325i d reg early car

no heat at all thru the fans

fan is blowing and theres no overheating at all of engine

some one suggested tstat could be missing??

what else could this be??

as many suggestions as poss please
want this fixed asap as its now bloody freezing up here
and after next week this will be my daily hack
cheers
Daz

Crossing my fingers for you that its not the heater matrix, you havent been playing with anything in the dash have you? My cousins one went last december and he went without a heater for a good few months as he couldnt afford to fix it!

or the heater duct could have come out? (no idea how it would fall off but you wanted as many suggestions as possible)

is engine at running temp?heater temp valve?(is one hose hot and one cold going to heater?)blocked heater matrix?


ill send ya some fishermans freinds and a flask for a tenner

all answers will be looked at dobbie

i have a feeling its gonna be a pain in asss job so the more things i can check the better

i havent messed with it got it like this
far too cold for no heat

will check all ducts

all seems to work perfect, just no heat

Simplest one is the dial that you turn to chose the temparature, it may turn on the outside but you could pull it out and test if its turning on the inside?

Might be worth trying to replace part 25:
http://www.realoem.com/bmw/showparts.do ... g=64&fg=20

Im sure someone on here could help you out.

Do you hear the 'clunk' when turning the dial from cold to hot?

No airlocks in the heater matrix perhaps?

check the heater valve by where it enters the matrix. they normally fail open so water can circulate round the matrix. mine was a bit iffy on my 316 so i tapped it gently and it started sending water round the matrix again. its been a while since i did that but if i remember rightly the bit u need to look for is on the left hand side of the matrix on one of the pipes. hope this helps, 2 minute fix if it is. good luck

Steviec wrote:Might be worth trying to replace part 25:
http://www.realoem.com/bmw/showparts.do ... g=64&fg=20

Im sure someone on here could help you out.

ed325i might have one as I left it in the dash I sold him, failing that I will be taking one out of my 318i sunday or wednesday if you can cope with the cold till then! (unless I can get it out without taking the dash off completely then i may be able to get it tomorrow if someone shows me how I take it out!)

still using the sport for a few
so ill get back to you Dobbie if i need that part
will have a good look and mess about with things over the weekend

cheers for all the suggestions so far

not really had a chance to have a look at the bypass valve in my bm if at all it has one but i had exactly the same thing in an old mk2 golf, it was that, the bypass valve, it's basicly a valve that stops alot of pressure building up in the heater matrix and in return cracking and pissing out everywhere inside the car, i'll have a look see if i see anything i reconise in my engine bay and look it up in the haynes

Very first thing to check is that the heater hoses are on the right way around.
The way that looks the most "correct" is the wrong way. Hose from the back of the cylinder head goes to the lower stub.

yeah, i made exactly the same mistake, i had heat for 20secs, then went cold