Page 1 of 1
H&R roll bar adjustment
Posted: Tue Aug 22, 2006 9:21 pm
by Jamesb318is
So, ive just bought a set, what have people found are good settings? I know i could play about with them, but there is 12 possible combinations, and that'll take a while!
Ideally i think i want to introduce a little more oversteer as my car tends to understeer when pushed.
Re: H&R roll bar adjsutment
Posted: Wed Aug 23, 2006 1:35 am
by Jhonno
ive got mine on med front and soft rear.. understeers if you stupid but will tuck in nicely if you back off the throttle
Re: H&R roll bar adjsutment
Posted: Wed Aug 23, 2006 2:12 am
by aus325
I have Ireland Engineering 25/22 swaybars on my 325i, and have to run the rear a little soft (mega-scary on any type of stiff setting!!). Fronts are currently set for middle adjustment, and turn-in is fantastic. Be sure to try as much adjustment as you can, the differences may only be subtle, but you will know when it's just right.
Re: H&R roll bar adjsutment
Posted: Wed Aug 23, 2006 12:56 pm
by jamesc
Jhonno wrote:ive got mine on med front and soft rear.. understeers if you stupid but will tuck in nicely if you back off the throttle
Same here....
Re: H&R roll bar adjsutment
Posted: Wed Aug 23, 2006 2:11 pm
by ItalianM3
I have 35mm cupkit and H+R Roll bars, I run the front on the softest and the rear on the hardest. Handles so well, if you set up for the corner you can take it at very fast speeds.
When I had the front on medium i was getting too much understeer. Could be my style of driving though!!
