Pipe from throttle body

Need technical Q/A then you're in the right place
Post Reply
User avatar
Foe
E30 Zone Newbie
E30 Zone Newbie
Posts: 221
Joined: Fri Sep 25, 2009 10:00 pm
Location: South Wales

Sun May 12, 2019 4:03 pm

So there is a pipe 'dangaling' from the throttle body. Any idea where this goes?
1991 316i.

Thanks
Cloggy Saint
Old Skooler
Old Skooler
Posts: 7288
Joined: Sun Jan 09, 2005 11:00 pm
Location: zummerzet

Sun May 12, 2019 7:09 pm

Without having a picture I would assume it's part of the emissions control. If the car had a cat' the pipe would connect to a charcoal canister that bolts to the inner wing. Is the end of the pipe blocked off?
Image

E30 zone - promoting adult illiteracy since 2004
User avatar
Foe
E30 Zone Newbie
E30 Zone Newbie
Posts: 221
Joined: Fri Sep 25, 2009 10:00 pm
Location: South Wales

Sun May 12, 2019 9:47 pm

The end of the pipe is blocked off. And thanks for the reply :thumb:
User avatar
paultv
E30 Zone Regular
E30 Zone Regular
Posts: 703
Joined: Mon Apr 21, 2014 10:00 pm
Location: Auf dem Schnee: Germany

Mon May 13, 2019 9:24 am

I reckon it's one of the vacuum advance retard pipe connectors for the distributor fitted to a few very early models - it has a short blanking tube ( rubber, which rots out and lets in air ) attached on all other models,

The short metal pipe drops from under the mounting flange of the throttle body and should have a stubby rubber blanking tube push fitted on.

If you look behind your alternator you'll see the blanked off fitting point for the not needed mechanical distributor on the side of the block.

I think there were two advance/retard pipes fitted to these very early cars but I'm sure Brian will show up and clarify this and all the rest if I'm wrong!

Paul :-)
4th May 1990 325i Convertible.

BMW E30 Cabriolet Best Mod Ever:

http://bmwe30cabriolet-wdm.blogspot.de/
Cloggy Saint
Old Skooler
Old Skooler
Posts: 7288
Joined: Sun Jan 09, 2005 11:00 pm
Location: zummerzet

Mon May 13, 2019 10:17 am

paultv wrote:
Mon May 13, 2019 9:24 am
I reckon it's one of the vacuum advance retard pipe connectors for the distributor fitted to a few very early models

On a '91 car?
Image

E30 zone - promoting adult illiteracy since 2004
User avatar
paultv
E30 Zone Regular
E30 Zone Regular
Posts: 703
Joined: Mon Apr 21, 2014 10:00 pm
Location: Auf dem Schnee: Germany

Mon May 13, 2019 10:50 am

No, I meant an early 80's car, but obviously no longer used, therefore the dummy block off.

but I'm probably mistaken anyway...

Paul :-)
4th May 1990 325i Convertible.

BMW E30 Cabriolet Best Mod Ever:

http://bmwe30cabriolet-wdm.blogspot.de/
User avatar
Foe
E30 Zone Newbie
E30 Zone Newbie
Posts: 221
Joined: Fri Sep 25, 2009 10:00 pm
Location: South Wales

Mon May 13, 2019 1:03 pm

Thanks for your help gents.
It doesn't seem to affect the running, just annoying that there's this pipe, going no where!
Cloggy Saint
Old Skooler
Old Skooler
Posts: 7288
Joined: Sun Jan 09, 2005 11:00 pm
Location: zummerzet

Mon May 13, 2019 1:19 pm

Remove the pipe and block off the stub on the throttle body.
Image

E30 zone - promoting adult illiteracy since 2004
User avatar
Foe
E30 Zone Newbie
E30 Zone Newbie
Posts: 221
Joined: Fri Sep 25, 2009 10:00 pm
Location: South Wales

Mon May 13, 2019 4:12 pm

Will do and thanks both :thumb:
User avatar
paultv
E30 Zone Regular
E30 Zone Regular
Posts: 703
Joined: Mon Apr 21, 2014 10:00 pm
Location: Auf dem Schnee: Germany

Wed May 15, 2019 10:48 am

4th May 1990 325i Convertible.

BMW E30 Cabriolet Best Mod Ever:

http://bmwe30cabriolet-wdm.blogspot.de/
User avatar
Foe
E30 Zone Newbie
E30 Zone Newbie
Posts: 221
Joined: Fri Sep 25, 2009 10:00 pm
Location: South Wales

Sat May 25, 2019 5:37 pm

So, following up on this, there is also this wire with an un-plugged connection. We have no idea where this goes, or what should it should plug into into?
We're going to replace the thermostat, for an OEM one as the fan is not kicking in when the engine get s hot.

Any ideas?
Attachments
IMG_20190525_130621.jpg
Post Reply