Help me please!
Posted: Wed May 23, 2012 3:22 pm
Right, 2 problems with my e30:
1, After replacing the water pump, bleeding the system, heaters blowing hot, all water pipes hot, no airlock? Topped up to max, which wasnt much an left it to cool down, tried it again, after about 5 minutes, temp gauge just over blue, heaters blowing hot. Airlock? Cant run it up to try again because:
2, Tried it again the morning after an it was misfiring, smokey, wouldnt rev, this problem happened over night an was running fine when i was running it up, but noticed a pulley had worn through the wire which has a ring on one end which a ht lead goes through, not sure were the otherside goes, what is this wire? Cant find anything, someone said its something to do with the crankshaft sensor, looked at pictures of m40 crankshaft sensors an none has the ring for the ht lead goes through?
Thanks, Mark
1, After replacing the water pump, bleeding the system, heaters blowing hot, all water pipes hot, no airlock? Topped up to max, which wasnt much an left it to cool down, tried it again, after about 5 minutes, temp gauge just over blue, heaters blowing hot. Airlock? Cant run it up to try again because:
2, Tried it again the morning after an it was misfiring, smokey, wouldnt rev, this problem happened over night an was running fine when i was running it up, but noticed a pulley had worn through the wire which has a ring on one end which a ht lead goes through, not sure were the otherside goes, what is this wire? Cant find anything, someone said its something to do with the crankshaft sensor, looked at pictures of m40 crankshaft sensors an none has the ring for the ht lead goes through?
Thanks, Mark