Page 1 of 1
Adjusting handbrake, which way to turn barrel?
Posted: Tue Apr 03, 2012 9:51 am
by jimf
Hi folks, can someone take the guesswork out of this job for me. Looking at each rear wheel face on and going through one of the wheelbolt holes with a flatblade screwdriver, which way do I turn the star adjuster for either side to tighten handbrake. I have done this job on other cars a few times but always end up going the wrong way and the job takes twice as long.
Thanks
Re: Adjusting handbrake, which way to turn barrel?
Posted: Tue Apr 03, 2012 4:26 pm
by unmol
im 80% sure its downwards, but if not just turn the drum by hand and if its rubbing / too tigh, turn the adjuster the oppisite way.

Re: Adjusting handbrake, which way to turn barrel?
Posted: Tue Apr 03, 2012 6:39 pm
by Brianmoooore
When facing the end of the adjuster that has the star wheel, you need to turn it clockwise to extend its length, but whether this is up or down depends on which way around the adjuster has been fitted.
A small light bulb, soldered to a piece of wire, connected to a battery and pushed into the drum via one of the other wheel bolt holes is an invaluable tool for this job. Lights everything up inside, and lets you see exactly what you are doing.
Re: Adjusting handbrake, which way to turn barrel?
Posted: Wed Apr 04, 2012 12:18 am
by e30-EVN
^ what an awsome piece of advise!!
A great idea brian

Re: Adjusting handbrake, which way to turn barrel?
Posted: Wed Apr 04, 2012 7:33 am
by jimf
Yeah, I'm liking that. Cheers.