Page 1 of 1

Is this an MOT failure or not..?!

Posted: Thu Mar 22, 2012 5:46 pm
by Jungian64
The touring is up for its MOT next week, so had a poke around...and found this behind the rear wheel - Iam pretty sure its the sleeve that goes around the fuel line from the filler to the tank - so is this a failure or not? and if it is, what can be done about it..?!!
Image
Image

Thanks.

Re: Is this an MOT failure or not..?!

Posted: Thu Mar 22, 2012 7:11 pm
by Brianmoooore
Won't be a fail as long as the hole is confined to the removable cover. A hole in the inner wing itself will be a fail if the hole is within 300mm of a suspension mounting point.

Re: Is this an MOT failure or not..?!

Posted: Thu Mar 22, 2012 8:28 pm
by Jungian64
Blimey..theres a removable cover under all that!

Re: Is this an MOT failure or not..?!

Posted: Thu Mar 22, 2012 8:29 pm
by Brianmoooore
Jungian64 wrote:Blimey..theres a removable cover under all that!
Not very much of it in your case, I fear.

Re: Is this an MOT failure or not..?!

Posted: Thu Mar 22, 2012 8:37 pm
by Jungian64
I fear, you're right!

Re: Is this an MOT failure or not..?!

Posted: Thu Mar 22, 2012 9:38 pm
by Grrrmachine
Mine went exactly the same way:

Image

The cover plate is held on with four plastic nuts (M8, IIRC), and one end pokes into the bodywork closest to the tank.

You can pick up new ones for a reasonable price, or even used ones if you're a penny pincher. If you're nimble, you don't even have to take the wheel off to swap it over.

Re: Is this an MOT failure or not..?!

Posted: Fri Mar 23, 2012 2:21 pm
by Jungian64
Nice one!

Your inner wing looks considerabley cleaner than my cow crud encrusted one!

Thanks for the tip off.

Re: Is this an MOT failure or not..?!

Posted: Fri Mar 23, 2012 7:42 pm
by aimlessrock
Mate, the cabby's have the same set up, i replaced mine few months ago, its a just a bolt on cover, the part was about £40.00 plus vat from memory from the main dealers