Page 1 of 1
QUICK QUESTION
Posted: Sun Oct 30, 2005 3:23 pm
by ukdirtyboy
Hi all
this may be a easy one but which way do you undo the bottom pully bolt on a 320 i m20 engine
thanks
Posted: Sun Oct 30, 2005 3:53 pm
by Jamesb318is
Anticlockwise, but it'll be FT so a brace on the pulley or something to stop it turning round (or a dirty great big impact gun) will be needed!
Posted: Sun Oct 30, 2005 3:58 pm
by tourer-dan
oh, it will take a whole lot more than that.......
Posted: Sun Oct 30, 2005 3:59 pm
by ukdirtyboy
thanx for info iam now gonna take some skin of my nuckles
Posted: Sun Oct 30, 2005 4:19 pm
by ukdirtyboy
well big big bar 17 stone and a hammer and pipe pilyer
still cant shift it are ya sure its anticlockwise
Posted: Sun Oct 30, 2005 4:54 pm
by Jamesb318is
Yep, the way we do it at work is with a bar/length of metal with a circle and three bolt holes in the end. This gets bolted onto the pulley, then braced on the subframe or under a 2 post ramp depending whether the lumps in/out of the car. Then undo with a big old breaker bar! Keep trying they do come undone, but they are done up to 300+ ft/lb!