E30 Zone

hi i am after some help with a few off the wires and relays on a 1989 325i loom.
i need to no what theses 3 relays are

and also on the injector loom plug is

INJECTORS
brown and white- (earth)
red and white- (live)

COOLENT TEMP SENSOR (blue)
Brown and red- (live)
brown and orange- (earth)

TEMP GAUGE (brown)
brown and yellow
also theres brown and pink but not on other side off plug

i also need to no what each wire is on the idle control valve wireing
ICV
green and white-
red and white-
yellow and white-

and the same for the tps sensor
TPS
blue and brown-
brown-
brown and black-

if anyone nos could they fill in the gaps for me please cheers mike.

White is DME (main engine) relay
Orange relays are fuel pump and lambda sensor heater. Fuel is the one with a green/purple wire going to pin 87.
Spare wire in injector loom is a left over from when E30s had two pin brown temp. sensors. The same wire that's present on pin 20 of the engine loom socket on some cars that causes a burn up when a later engine loom is fitted.
ICV: red/white is 12 volts + from the DME relay, other two are the signal wires for the balanced armature design.
TPS: brown is earth, brown/blue is idle, brown/black is WOT.

cheers for the quick replay