E30 Zone

hi all i am in need of some help hear
i can not get the rear subframe out of my e30
all bots are out it will not drap down from the bady of the car....
wot can i do......


well nice

simon

I had to use a long lever with some brute force, applied between the top of the beam and the underside of the body at each end, Eventually it popped out, if you're not careful you will damege the underside though.

It was a pig to get off mine, big bar and pry it down! I spent ages with heat guns, freeze spray, wd40, I just had to man up and beast it off.

Poke a tight fitting drift(i use an old 3/8 drive ratchet handle) up into the bush and GENTLY tap it side to side and forward backwards.Take care not to belt it too hard and it will drop out.
Be warned that the top part of the bush centre can and often does break off in the chassis which can be a bastard to get out!

The way i do it is take the main 22mm nuts off knock the bolts into the car then rock the beam with my foot on the trailing arm and it normally drops down easy enough some times it leaves the alloy bits of the bush in the body but i just tap them with a big hammer and they normally fall out

ok all nice one i will have a go to day and let you know......

nice one for all for replys

simon

hi all one for thingh i have got a m42 engine and need a WINDSCREEN WASHER BOTTLE i have read you need a v12 WINDSCREEN WASHER BOTTLE as my old one will not fit can i get this one or do you know where i can get one.....


http://cgi.ebay.co.uk/WINDSCREEN-WASHER ... 3a54fc2095


nice one
simon

all E30 washer res fit in the same place, i fail to see why your original one will now not fit dude ???

the coil pack is in the where it will not fit back in

have you put the coil pack in the wrong place somehow?...that is a strange one.. or is your bracket snapped/fell off


Take a picture..loads easier

ok cool will do that and haw do i put pix on hear too???

nope still can not get it out this is not good woz at it all day too day and nope @~@?> @~}{:? ~@;} car @#{~@?~ car @:@

i am going to cut it out f@~k it god dam car.....

and i still got to put my engine in.........long time.......

nice
simon

just put new subframe bushes in my self
one side was bust and the other was a pig had to air saw the rubber in the old bush and porter power the subframe down

ok got it out 2 weeks later.......not bin fun......my dad made a tool to get it out.......
but there is the iner bar is still in the car have to get this out still

nice one for the help..


simon

if you need this tool let me know you can use it..

blademankiller wrote:the coil pack is in the where it will not fit back in

This is how it should look

ok cool and that is a m42 engine???



simon

ok cool i got it nice one for all your help zones

simon