Page 1 of 1
Please help with seat problem
Posted: Tue May 18, 2010 10:12 pm
by 318
I am trying to remove the seat mech and I have got as far as the pic below but the mech don't want to move at all please help
Many thanks
Re: Please help with seat problem
Posted: Tue May 18, 2010 11:01 pm
by toby
Re: Please help with seat problem
Posted: Tue May 18, 2010 11:24 pm
by 318
That is what I have followed and it says
Unbolt the 17mm bolt holding the mechanism to the lower pivot.
Lift off the mechanism paying attention to the latch towards the rear.
I have done this but it still don't want to move
Re: Please help with seat problem
Posted: Wed May 19, 2010 11:12 am
by toby
Have you moved the mechanism from the above picture to this position so that this tilt-stop-peg doesn't stop it coming off?

Re: Please help with seat problem
Posted: Wed May 19, 2010 5:41 pm
by 318
No but I will go and give it a go now
Thanks mate
Re: Please help with seat problem
Posted: Wed May 19, 2010 6:28 pm
by 318
Thanks mate that worked a treat but my next question is how does this knob come off I have unlinked it from the support but still it don't want to move

Re: Please help with seat problem
Posted: Wed May 19, 2010 7:17 pm
by toby
The round knob, I think it just pulls off. It's probably just really tight and you will end up punching yourself in the face with it when it finally lets go suddenly.
Re: Please help with seat problem
Posted: Wed May 19, 2010 7:32 pm
by 318
That did the job just very stuck

Re: Please help with seat problem
Posted: Thu May 20, 2010 9:22 am
by toby
Good stuff. Keep posting if you have any more questions.