Page 1 of 1
Chip question.***not usual crap***
Posted: Tue Aug 23, 2005 1:43 pm
by rowemeister
I am going to get MAF conversion done soon and realise I need a unichip.
Now I have in my possession a Race Logic piggy back chip.
I was wondering if this could be used as a replacment for the unichip.
The eprom on the small pectal pcb is a standard M27C256 type.
Posted: Tue Aug 23, 2005 1:46 pm
by CaesarBob
No idea m8. You may remember i'm useless with stuff like this.
You lost me at the "Unichip" bit ..
Posted: Tue Aug 23, 2005 1:48 pm
by rowemeister
nice one.
Posted: Tue Aug 23, 2005 1:50 pm
by CaesarBob
In my expert opinion
... it'll work perfectly!
Posted: Tue Aug 23, 2005 1:51 pm
by rowemeister
Posted: Tue Aug 23, 2005 1:54 pm
by CaesarBob
Anyway
... someone with half a brain cell will be along shortly to answer this.
Posted: Tue Aug 23, 2005 4:42 pm
by rowemeister
Hello does anybody know
Posted: Tue Aug 23, 2005 5:01 pm
by CaesarBob
Apparently i'm not the only stupid one round here.
Posted: Tue Aug 23, 2005 5:04 pm
by M5pilot
You can get it remapped to run with the MAF, you'll save like Ԛ£100 or so but later adjustments will mean you'll have to get another remap done.
Can that chip be copied?
Posted: Tue Aug 23, 2005 5:56 pm
by tourerti
You can not copy that chip, it is evc protected.
Posted: Tue Aug 23, 2005 6:02 pm
by M5pilot
aaaaahhh
can u buy them?
Posted: Tue Aug 23, 2005 7:25 pm
by tourerti
You can bu the replicator and the base but they can not be coppied unless you can break 256bit encryption which would cost more than programming your own map for the conversion.
See here,
http://www.evc.de/en/
Posted: Wed Aug 24, 2005 8:25 am
by rowemeister
No I cant copy this chip. I can however copy the main eprom but it is mapped with the pectal pcb so its pretty useless.
Sal are you sure this chip can be used then for a one off custom map with MAF. If thats the case I may as well use it.
I dont see me doing anything else to engine has most stuff is sorted.
