badge/emblem
Posted: Fri Nov 13, 2009 2:44 pm
What are the sizes and part numbers of the bonnet and boot emblem please.
51148132375 - front one
51141872969 - back one
Not sure about size - 82mm diameter rings a bell.
Page 1 of 1
Re: badge/emblem
Posted: Fri Nov 13, 2009 4:59 pm
Re: badge/emblem
Posted: Fri Nov 13, 2009 5:43 pm
If you go on eBay there's loads on there
Re: badge/emblem
Posted: Fri Nov 13, 2009 5:51 pm
I did not know there was a difference between back and front. I bought 2 of ebay that were same part number anyway. Fitted one to bonnet and was fine still to do boot.
Re: badge/emblem
Posted: Fri Nov 13, 2009 8:28 pm
Yeah Ive just bought some, I think its 82mm for front and 88mm (?) for boot. Search for 'genuine' BMW badges or else you might end up with really bad quality ones 
Re: badge/emblem
Posted: Fri Nov 13, 2009 8:31 pm
Bonnet & boot are indeed different - touring boot is different again.
Re: badge/emblem
Posted: Sat Nov 14, 2009 6:54 pm
Thanks.ChemicalAl wrote:51148132375 - front one
51141872969 - back one
Not sure about size - 82mm diameter rings a bell.
Re: badge/emblem
Posted: Sat Nov 14, 2009 10:35 pm
Bonnet badge is same thickness all the way around - for a flat horizontal surface. The boot one is thicker at the top to fit nicely with the angle of the boot edge. If that makes sense.
That said, the flat ones will fit the rear. It depends on how much of a stickler you are. The eBay ones I have seen are the flat type. I got a relatively cheap one for the front and the quality is good - if it fades, they are cheap to replace
That said, the flat ones will fit the rear. It depends on how much of a stickler you are. The eBay ones I have seen are the flat type. I got a relatively cheap one for the front and the quality is good - if it fades, they are cheap to replace
Posted: Sun Nov 15, 2009 12:37 am
Can't remember. I painted over both of mine 