E30 Zone

hi there guys.... simple enough query but need some advice......

my fan heater is dead on position 1,2,3 but 4 is fine....this MUST be the rotary switch right???? or cud it be a lose wire?

not had the problem myself but i believe it's common and to do with the resistor pack, not the switch.

breezebreeze30 wrote:hi there guys.... simple enough query but need some advice......

my fan heater is dead on position 1,2,3 but 4 is fine....this MUST be the rotary switch right???? or cud it be a lose wire?

Sort out the sig and your hardtop please

Until you have somthing worth showin work on putting ur money where ur mouth is u phen da phuda!

Garath so can i just change that whole unit?behind the dial?

breezebreeze30 wrote:Until you have somthing worth showin work on putting ur money where ur mouth is u phen the phuda!

Garath so can i just change that whole unit?behind the dial?

Money where my mouth is?
im hardly gonna come to ur house change your sig and spray ur hardtop am i C*ck

You would imagine that it's fairly simple, will. If there's any hint of a technical question in the original post, then it should be posted in 'tech help', but there are plenty on here who don't seem able to work that one out!!

phen the phuda!

What a way to let out your punjabi lol

mynes exacally the same!! i made it work on 4 but then it cuts out after a while then i took it apart put it back together then it works for abit longer! i would like to know what the problem is aswell

It is a common problem. Something to do with the resistor pack. I`d do a quick search under technical help if I were you. Plenty of threads for a relatively simple fix.

Good luck.

cheers lads......the feedback was much appriciated.

Bear in mind that if your fan motor is becoming stiff, through lack of lubrication, it will draw excess current, and your new resistor pack may not have the length of life that BMW intended.