Page 1 of 1
E30 touring 318 M40 engine .
Posted: Sun Sep 27, 2009 4:22 pm
by simufly
Just doing the cam belt and have noticed that there is an reinforced cable that runs outside the front cover. This is held in place by a metal clip, (now broken) this wiil allow the cable to rub against the rear of the fan pulley.
Cant see how to replace the clip and cant find it on the EPC.
Anybody any ideas?
Re: E30 touring 318 M40 engine .
Posted: Mon Sep 28, 2009 9:47 am
by simufly
bump
Posted: Wed Sep 30, 2009 12:16 am
by engine_ear
Is this the wire that runs to the crank sensor? I had the same issue and zip tied it in place, a bit fuzzy on quite what I zip tied it to but it seems to be holding
Re:
Posted: Wed Sep 30, 2009 3:13 am
by town325i
cable tie it to the alloy hose going to the main hose and you should have no troubles
Re:
Posted: Wed Sep 30, 2009 1:37 pm
by simufly
Will cable tie it pro tem, but now have all the clips shown on the diagram just forgot to remove the old bit when I had it in dismantled. doh