Page 1 of 1
M20 325 HEAD
Posted: Tue May 19, 2009 11:13 pm
by boydy
hey guys, bought one of these off e-bay, needs the cam shaft and rockers put in, is this hard to do?
Re: M20 325 HEAD
Posted: Tue May 19, 2009 11:17 pm
by Brianmoooore
If it's from ebay, the first thing is to get it crack tested and checked for flatness!
Re: M20 325 HEAD
Posted: Wed May 20, 2009 7:28 pm
by boydy
yeah got that done brian, what next? cheers for info
Re: M20 325 HEAD
Posted: Wed May 20, 2009 10:23 pm
by Brianmoooore
Cam in first, then push the rocker shafts in, threading the rockers on as you go, with the adjuster eccentrics either turned fully in or removed. Keep the rockers off of the valves, and by turning the cam, you can slide it all together.
Move the 'loose' rockers onto the cam lobes, and fit the clips, turn the cam, and slide the remaining rockers in place.
Finally, fit the locking plate for the rocker shafts, and turn the cam pulley to line up the timing marks.
Re: M20 325 HEAD
Posted: Thu May 21, 2009 7:08 pm
by boydy
cheers for help brian