Page 1 of 1
Rear bearing/Drive flange Torque setting?
Posted: Sun Jan 04, 2009 11:44 pm
by wildeian
Is there a Torque setting for the nut that holds the drive flange on the drive shaft, and the bearing in place?
Haynes only has 5 series setting!!??
(325i Touring)
Re: Rear bearing/Drive flange Torque setting?
Posted: Mon Jan 05, 2009 11:37 pm
by wildeian
Nobody??
Can they be over-tightened?
Re: Rear bearing/Drive flange Torque setting?
Posted: Tue Jan 06, 2009 12:27 am
by ROC
Wildeian, the rear hub/axle nut torque settings are 195 to 210 Nm (144 to 155 ft. lb.)
HTH,
Rich.
Re: Rear bearing/Drive flange Torque setting?
Posted: Tue Jan 06, 2009 3:22 pm
by Barx325i
torque settings are for wimps
