Page 1 of 1
help pls m tec 2 rear bumper on pi face left cab
Posted: Sat May 10, 2008 12:06 am
by cliff
I have a pri face left convertiful and am about to fit a m tec2 rear bumper!
Where do i weild these bractkets! To hold the sides of the bumper on!!
i know its 2.2mm down from the swage line. but i forgot to measure from the rear arch swage line to the begining on the bracket!!
Can anyone pls help !
all help will be usful !hh
Re: help pls m tec 2 rear bumper on pi face left cab
Posted: Sat May 10, 2008 4:44 pm
by cliff
can eney one help i am about to go and fit it i will start by drilling the holls for the rear mountings then its on with the welding so nead that meshormant eny one pls
Re: help pls m tec 2 rear bumper on pi face left cab
Posted: Sat May 10, 2008 5:19 pm
by o22ie
have a look in the articles mate,,, there is a very good tutorial about this in there
Re: help pls m tec 2 rear bumper on pi face left cab
Posted: Sat May 10, 2008 7:42 pm
by cliff
cheers for that but the only articile i could find in there was for fitting the tec 2 kit to a face lift, i want to fit it to a preface lift pls correct me if i am wrong .
there must be loads of people that have done this
my bumpar and tec to kit is all together and sprayed just need to now whether to weld this metal bracket that the plastic bracket bolts to that holds the side off the bumper in place