. . . is it easy to do? Pretty sure the reason i have no clutch is a leaking slave cylinder, (pool of fluid under car, biting point moved when you pressed the clutch down for anything more than 5 seconds before it went completely). I have one removed from a pre-facelift 320i, only a few months old - will it fit my 1989 325i?
Thanks in advance.
Clutch slave cylinder replacement.
Moderator: martauto
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
Two 13mm nuts,I think.
Top one can be playfull to get at,try to slack off the hose before you remove the cylinder.Flexi is horribly expensive via BMW,but some-one put up a link to an Ebay s/s one the other day,a far more reasonable £22ish.
Most suggest that the master cylinder is swapped at the same time.
Top one can be playfull to get at,try to slack off the hose before you remove the cylinder.Flexi is horribly expensive via BMW,but some-one put up a link to an Ebay s/s one the other day,a far more reasonable £22ish.
Most suggest that the master cylinder is swapped at the same time.
Youth is wasted on the young.
S/s hose is something I must get, any idea who posted it up Malc? I'll get searching for it.
---EDIT---
Unbelievable I found it using the search
http://www.ebay.co.uk/itm/BMW-3-Series- ... 45fcc6c924
---EDIT---
Unbelievable I found it using the search
http://www.ebay.co.uk/itm/BMW-3-Series- ... 45fcc6c924
-
Von_Thrash
- E30 Zone Newbie
- Posts: 80
- Joined: Sat Jul 11, 2009 11:00 pm
Happy 
Got home from work at 6pm, just finished a short test drive after fixy fixy. Thanks again!
Got home from work at 6pm, just finished a short test drive after fixy fixy. Thanks again!