Page 1 of 1
how mould you check an alpna?
Posted: Tue Apr 10, 2007 6:22 pm
by slippo
how would i go about checking an alpina out, to see if it all stands up properly? any ideas? if the car was hpi`d would it show in the description as bmw alpina, or not? i have tried the vehicle checks and it just says bmw, no alpina on there, thanks
Re: how mould you check an alpna?
Posted: Tue Apr 10, 2007 6:35 pm
by Rosc0PColtrane
Sytners registered the cars before converting them so will show up as normal cars.
It should have an Alpenis plate below the heater switches for starters.
Re: how mould you check an alpna?
Posted: Tue Apr 10, 2007 6:43 pm
by slippo
is there no other way to tell?
Re: how mould you check an alpna?
Posted: Tue Apr 10, 2007 7:00 pm
by kam-325i
How deep do you want to go?
Re: how mould you check an alpna?
Posted: Tue Apr 10, 2007 7:32 pm
by kidsinister
What is it? C2 2.7?
Re: how mould you check an alpna?
Posted: Tue Apr 10, 2007 8:30 pm
by SDM
phone up sytners, only way...
i heard they are charging for this now??
Re: how mould you check an alpna?
Posted: Tue Apr 10, 2007 8:52 pm
by kidsinister
They are, and will only provide info to the registered owner.
Re: how mould you check an alpna?
Posted: Tue Apr 10, 2007 8:53 pm
by dilo_attax
does it say alpina at the back.....lolz..
Re: how mould you check an alpna?
Posted: Tue Apr 10, 2007 11:36 pm
by kidsinister
dilo_attax wrote:does it say alpina at the back.....lolz..
Has it got a stupidly mahoosive front spoiler, and shit brakes?