Page 1 of 1
mix and match
Posted: Sat Apr 02, 2005 6:28 pm
by liam325i
can ne one tell me if you can fit a genuine mtec2 kit to a early 325i convertable? ? ?
Posted: Sat Apr 02, 2005 6:39 pm
by Davenotouring
I think it requires some work, someone will tell you the specifics I hope.
Where in Cambridge are you from?
I'm at Uni down in Brighton, but my parents live in Orwell, south of Cambridge.
Posted: Sat Apr 02, 2005 6:49 pm
by Geeman
He's not going to tell you that! You could be some kind of wierdo... Hold up... you ARE a wierdo!
Posted: Sat Apr 02, 2005 6:51 pm
by Davenotouring
Geeman wrote:He's not going to tell you that! You could be some kind of wierdo... Hold up... you ARE a wierdo!
Liam asked me and Demlot from memory on another thread, I just remembered that I didn't reply on that one so I thought I would reply here!!
Posted: Sat Apr 02, 2005 7:32 pm
by Zayyan
I think I'm right in saying that everything'll go on fine except the rear bumper, which'll need to be modified slightly due to the pre-facelift cars having higher arches?
Posted: Sat Apr 02, 2005 8:16 pm
by Geeman
Pre-facelift cars have lower arches...
Posted: Sat Apr 02, 2005 8:43 pm
by Zayyan
Close enough
Posted: Sun Apr 03, 2005 7:26 pm
by liam325i
im from jst outside cambridge on the way to newmarket i only see a few nice e30s drivin about a havent seen yours about im thinkin of puttin a genuine mtec 2 side skirts, rear bumper and e36 m3 evo ft bumper or a hamann one on it what you think?