E30 Zone

Intend to waxoyl my cab some time this week, need some advice from anybody that has done this before i.e best places.In side doors obviously but where else that is easily,or not,reached.While im here how can i re-align my steering wheel,just cant get it right and its driving me nuts

TO do it well, you need to sprip out all the boot carpets, then spray it everythere!

Take the sill covers off and spray into all the holes you can see, but only enough to cover the surfaces as the sils have dranage points under the car and if these get blocked it could cause rust longterm.

Then take the rear door cards out spray it all in there.

The best stuff is from BMW and costs Ԛ£10 it will do most of the car.

Andrew

Shit.ive had all my interior out for best part of two weeks and put it all back in on thursday.
Nothing like forward planning eh!!!!!!!!!!!

Hi, try to get hold of a lenght of flexi tube that wil fit over the end of the nozel that you are useing. put a bung at the end of the tube and make a serias of small holes in the tube so it will spray the wax out in a fan pattern 360deg, then as you spray pull the tube back out of the sill you will get better coverage this way

dont get it on you. its sticky shit!

thebigone, ingenious!! Proper blue peter

FBF wrote:dont get it on you. its sticky shit!

Fat chance mate,id get dirty in a sugar factory

Demlotcrew wrote:TO do it well, you need to sprip out all the boot carpets, then spray it everythere!

Take the sill covers off and spray into all the holes you can see, but only enough to cover the surfaces as the sils have dranage points under the car and if these get blocked it could cause rust longterm.

Then take the rear door cards out spray it all in there.

The best stuff is from BMW and costs Ԛ£10 it will do most of the car.

Andrew

Andrew you would,nt have part number or code would you,only just rang dealers and they say all they do is wax.

O by the way it goes better if you warm it up. Stand the what ever in a bowl of hot water for 10mins, this idea might just get me my gold badge LOL

Another good tip is to make sure the switch on the nozzle is in the off position before pressurising