Page 1 of 1
how to use bmc with m20 b25 airflow meter
Posted: Thu Dec 05, 2013 8:12 pm
by 320
Hi all, I have bought a bmc carbon filter with the round end, can anyone tell me how to match it to the airflow meter as it doesnt fit the square of the meter, thanks
Re: how to use bmc with m20 b25 airflow meter
Posted: Thu Dec 05, 2013 8:51 pm
by jmc330i
From memory the BMC boxes should come with an adaptor that bolt to the AFM.
Re: how to use bmc with m20 b25 airflow meter
Posted: Thu Dec 05, 2013 9:00 pm
by 320
jmc330i wrote:From memory the BMC boxes should come with an adaptor that bolt to the AFM.
It is a used item that I bought of a friend, it was bought for a vw, can the adapotor be bought seperate from anywher?
Re: how to use bmc with m20 b25 airflow meter
Posted: Thu Dec 05, 2013 9:02 pm
by reggid
it is available, I've seen them on ebay
Re: how to use bmc with m20 b25 airflow meter
Posted: Thu Dec 05, 2013 9:28 pm
by 320
reggid wrote:it is available, I've seen them on ebay
Ive searched there and there are no adaptors for the square part, iv also been on the cda website and theres nothing on their acessories section.
Posted: Thu Dec 05, 2013 10:08 pm
by jmc330i
A very quick search found these couple...
http://m.ebay.co.uk/sch/i.html?kw=e30+a ... SREF&cid=0
You would need to check sizes etc for your exact CDA.
Re:
Posted: Thu Dec 05, 2013 10:31 pm
by craigieeb
You also need to check the flow rate of the filter, if it's not the right one for your engine, say it's from a 1.6 etc..
it will choke up and cut out!
Posted: Thu Dec 05, 2013 10:37 pm
by 320
Thanks for that, I tried quite a few search words witch came up with nothing I was looking for.
