advice on fitting SE skirts to an I.S
Posted: Tue Dec 25, 2012 10:54 pm
hello any advice would help loads, i don't really want to drill any hole to attach these so what the next option iv had people say no more nails but i was hoping for something that's used in the motor trade not for putting up shelves etc so any ideas ?
iv current got 4 of the black clips for either sill and another 5 for the other and this is how it sits. one side is a bit difficult as from the looks of it its had one sill replaced in its like leaving the bottom lip bit wider than usual, i can wedge the black clips on but have to give them a hit with a hammer to do so.
hers a pic this is tape on the sill to the doors just for a look at what it will be like
iv current got 4 of the black clips for either sill and another 5 for the other and this is how it sits. one side is a bit difficult as from the looks of it its had one sill replaced in its like leaving the bottom lip bit wider than usual, i can wedge the black clips on but have to give them a hit with a hammer to do so.
hers a pic this is tape on the sill to the doors just for a look at what it will be like
