E30 Zone

righto, as per the above,

my h plate 318is is heading for its MOT on tuesday, im going to give it a proper going over on friday night and do anything it needs over the weekend,

its been off the road for 3 years, however,

its has,
a new full ss exhaust,
new discs+ pads all round,
new coilovers all round, new wheels and tyres,
new seats and harnesses,
i ran a new earth to the rear lights as it was a little dodgy, all sorted now tho!

I recently stripped it down and did a full respray, so there is no rust inside or out, it needed a little welding (rear inner arch) so that has been done!

so other than what i have already done, where do these usually go wrong?

thanks!!

Headlamp alignment, rear beam bushes, crusty brake and fuel lines.
Often just running your fingers along the lines can improve their appearance dramatically enough not to attract the attention of a MOT tester.