Page 1 of 1
Does anybody have access to a pipe bending mandrel?
Posted: Thu Sep 02, 2010 8:58 pm
by Brian28
Anybody have one at home in the workshop, or can access one at work? Something like an exhaust machine would be perfect, to stick a couple of bends in some 2" stainless.
Cheers
Brian
Posted: Thu Sep 02, 2010 9:38 pm
by e30cossie
If not could you buy some bends ?
Re:
Posted: Thu Sep 02, 2010 9:42 pm
by E30BeemerLad
Posted: Thu Sep 02, 2010 9:58 pm
by e30cossie
What I do if you cannot take the vehicle is.
Go to b&q and buy some flexi extract duct 2".
fit it to your car in position.
fill it with expanding foam as a template and take it to power flow.
I hope this helps.
Re:
Posted: Fri Sep 03, 2010 7:01 pm
by Brian28
Some good ideas there thanks chaps. I need to make up a manifold to fit bike carbs to an M42, running through the options.
Cheers
Brian