Page 1 of 1
is there anyone who can fit chip to a double board ecu??
Posted: Mon May 17, 2010 7:54 pm
by iceox
got a mild chip with my new 325 and fancy fitting it. i tried to do it today and i can just see me breaking something so i'll give it a miss. its the double board ecu so its a bit tricky. if theres anyone who knows what there're doing in the ipswich area who's willing to do it for a couple of quid give me a pm.
cheers josh
Re: is there anyone who can fit chip to a double board ecu??
Posted: Mon May 17, 2010 8:01 pm
by Falkster
Im a spaz but honestly theyre not difficult at all. Theres a 'how to' somewhere, might be on zone wiki.
Re: is there anyone who can fit chip to a double board ecu??
Posted: Mon May 17, 2010 8:06 pm
by iceox
yeh thats what i thought, but its a double board one so you cant really get to the chip properly so its quite nit piky. i was trying the get them apart today and slipped and nearly smashed the bloody thing lol.
Re: is there anyone who can fit chip to a double board ecu??
Posted: Tue May 18, 2010 12:12 am
by Ant
which ECU ? 073 or 164 ??
Re: is there anyone who can fit chip to a double board ecu??
Posted: Tue May 18, 2010 9:55 am
by iceox
just took a look and all it has is 1722190 and 078 on its own. fook knows lol
Re: is there anyone who can fit chip to a double board ecu??
Posted: Tue May 18, 2010 10:09 am
by d6dph
Ant wrote:which ECU ? 073 or 164 ??
If anyone can, He can. Ant is a legend and probably the most qualified person in this part of the country.
Re: is there anyone who can fit chip to a double board ecu??
Posted: Sun May 30, 2010 11:06 pm
by Tyra
I had the same issue - had a 164 double board, it drove me POTTY trying to figure out why it wasn't working and how to separate the top from bottom, wasted a lot of time being confused before realising it was me being a bit special
My solution was to buy a second hand single board from the parts section here and chip that instead! LOL