E30 Zone

Look at this little beaut!

Nice, but the wheels dont quite do it for me. Especially in that colour. Not slating it though!

..has anyone ever put teledials on an E30?

Have a look at Snooka's E30

ImysE30 wrote:Have a look at Snooka's E30

Lot of work went into that one

Founds some more piccies

will these wheels fit straight on?

you will need adaptors. . .4x100 to 5x130 if im correct. these are the ones i had on mine. pics below.

Best place for these wheels? Ebay?

E30GAV wrote:you will need adaptors. . .4x100 to 5x130 if im correct. these are the ones i had on mine. pics below.

any pictures of them on, really like this wheel on an E30

are they off the 944?

964 and 944 S2 I think (circa 1990-92)

How safe is it to run cars with adaptors? Dont they cause more wear on wheel bearings?

There was a bit of a debate on the 'US forum that this car was featured on, got the link here somewhere

I think they are nice, but would have had them in silver or chrome. Where the hell is that your zooming down the road in with no front plate??

EThreezero wrote:I think they are nice, but would have had them in silver or chrome. Where the hell is that your zooming down the road in with no front plate??

It's in Portland Oregon I think (just spotted the car on rv3limited, it's not mine)

You're not going to put any more stress on the wheel bearings as porsche tend to use very high offsets, so even with an adaptor they're within reasonable limits.

Design 90s came on various porsches in the 90s in various widths and offsets. Stagered fit forged 928 versions are the most sought after and most expensive.

rh306 wrote:

EThreezero wrote:I think they are nice, but would have had them in silver or chrome. Where the hell is that your zooming down the road in with no front plate??

It's in Portland Oregon I think (just spotted the car on rv3limited, it's not mine)

Ahhhhhh! thought it looked like somewhere american.

i like that

Quick thought , with those adapters would you be able to run the 16" BBS wheels that you would find on the M3 with out any issue?

No because m3 bbs are 5 x 120 mm and already a fairly low offset. You do occasionally see Porsche fit bbs rs pop up for sale though

harry_p wrote:No because m3 bbs are 5 x 120 mm and already a fairly low offset. You do occasionally see Porsche fit bbs rs pop up for sale though

Were they the ones that were gold on the inside orginally?

Was it the Targa's that normally had those wheels?

harry_p wrote:You're not going to put any more stress on the wheel bearings as porsche tend to use very high offsets, so even with an adaptor they're within reasonable limits.

Design 90s came on various porsches in the 90s in various widths and offsets. Stagered fit forged 928 versions are the most sought after and most expensive.

I have staggerred design 90s on my £300 944, if it all ends in flames and tears at the welders they will be for sale !

i do like that alot

That looks pimp!

i love these wheels would love to own a pair