E30 Zone

My pre face lift 1988 e reg 320i has the standard single outlet back box but i want to fit a 325i system/backbox but what tail pipes should it have?slash cut/angled/straight.as i want it to look period.any picture would be grate.

If it has not body kit then angled tails with OEM chrome tips.

Mine :



Has been replaced with a stainless system at some point but I think its the same design as the OEM stuff.

I like the angled stuff as well but its a bit marmite

So straight out slash cut..no it hasnt got a body kit.

My Dad's old 1987 325i had a GSF replacement back box which was straight out stright cut!

Its just preference I think? I will have a look for some pictures for you!

These are all 325i's!

Straight out, straight cut!



Sort of kink to the side, But straight out, Straight cut!



Straight out, Slash cut!



Angled exit, slash cut!

MMM im undecided!i have a complete system the same pipes as the blue c plater.

If it was my car I personally prefer the slash cut, But don't mind either angled or straight exit!

Either way twin pipes ftw!

What about sidewards slash cut?

Im thinking about one of these for mine







Would it look better than the le-mans tailpipes?

If your getting scorpion STW tails then get them without the gash scorpion logo. I did.

Mmmm im undiced,i like the slash cut sidewards exit type

Danthe --> did you get the STW version?
I am also very tempted by the STW scorpion for my chromie cab.
Is the length of the tailpipes the same for Le Mans and STW?

I contacted Scorpion and they can make a backbox with STW tips, but I will have to wait until they make a new batch of e30 exhausts...
Other places to buy?