E30 Zone

Added an M3 bumper gasket to my tech 2 bumper,




Here it is after giving the flank of the car a good going over -strangely it looks more henna in this light.

Anyway should i have another go and get it to sit right, or bin the whole idea?

All the best!

Chris

How much was it Chris? I've been thinking of doing this on my turd. Quite like the way it looks.

Cheers Dave,

It was fairly cheep -cant remember off-hand as i have had it over 6 months,

If i had realised the way it was going to sit as i put the bumper back on it i would have trimmed it down a lot better as it stands it sits ok-ish, but with a fresh gasket and the right trimming down it should look a lot better...

Good idea but angle of the picture is difficult to tell if its sitting correctly?

i really could do with getting a better picture for this but for all intents and purposes it sits as it should...

I think it looks good,really tidy's up the front end

Deep breath....... OK here goes...





















That's a damn fine looking moredoor there! There, I've said it.

Looks good IMO

Very kind guys, i'll try and take pictures of the next one i attempt to show where it needs trimming down,

So we think this works then?

I think it looks cooool

Looks really good suits your car and is different to others... spot on!!

Forgive my ignorance but what purpose does it serve?

what are we looking at? is it the bit between the bumper and the front panel?

It's been bugging me for ages as to what's different about your front bumper. I like that little gasket thingy ma bob too

lol! its a tech 2 bumper with satin black sprayed into the recesses -and yes its the black rubber bit that sits between the upper part of the valance and the top of the bumper

Cheers guys -very kind!