E30 Zone

Hey, anybody got any photos of an m20 on carburetors, searched high a low for some and cant find any!

Thanks

oakey wrote:

Those ain't carbs!!

Nice slide throttle set-up, though

imagine the noises they must make at 4Krpm+full throttle......

Fushion_Julz wrote:

oakey wrote:

Those ain't carbs!!

Nice slide throttle set-up, though

I know but they give an idea dont they

they give me an idea in my pants

jaistanley wrote:they give me an idea in my pants

haha so does your picture!


Thanks guys, just looking to see about clearances on no6 piston, as iv got a few dcoes knocking around!

If you're talking about the clearance to the brake servo, you will need to either move/remove the servo and master cylinder or make a custom trumpet for that inlet...

To that end take a look at Old_Skool 's posts about his S50 swap and the pictures in my S50 swap post. We've moved our servo's over a couple of inches.. Bit of fabrication but easy enough if you can cut and weld.





It's a golf MK2 1.3 servo, Audi master cylinder (mines a 25mm for my E36 M3 brakes) ans a golf reservoir. Moved over 57mm (53, something like that).

Fushion_Julz wrote:If you're talking about the clearance to the brake servo, you will need to either move/remove the servo and master cylinder or make a custom trumpet for that inlet...

could i not use a Golf servo, like the people do when there running the s50 engines?

ah i see, cool thanks very much!

Itb's at full chat sound amazing.

Hi

this my set up (not the manifold for sale)

nothing short of stunning mate! Still confused on the whole dizzy lark, how does it fit and where!?
In the end what did you do about the brake servo etc?

Dont by any chance want to sell all of that!????