well i'm asking this because it's got 700-800rpm to rev limiter and the car gives most hp at 6000rpm so why the car won't use that
my friend has e36 320i and it hits 220kph and limiter stops it on 6???rpm why e30 is not using all rpm
me and him are having standard diff
what is wrong with my car it hits 200kph at 5500rpm and it simply wont go faster, why ????
it is pre-facelift 87. 320i with LE-Jetronic, new spark plugs and filters, diff is i think 3.91
ok, these are NOT my pictures but i did this on VDO http://img483.imageshack.us/img483/4382/vdo1wk8.jpg http://img259.imageshack.us/img259/9245/vdo2wg0.jpg and on Hella http://img356.imageshack.us/img356/267/hella1bl1.jpg http://img356.imageshack.us/img356/8471/hella2id5.jpg what did you do datourer...
sorry to dig this thread out of history but i need help!! i took the two cc-s from scrapy one was VDO and other is hella and destroyed the pin 25 on both as i read on the ZONE and on e30.de BUT when i plug them they are not working, it just lights "motor oil" LED and thats it, on both of them i didn...
help i f... up i read on forum that 4door seats can be modified to 2 door model so i bougth some sport front seats from touring...and i removed the back of the seat and found out that there is no side holes for handels and no mechanisam for lifting, on my old seats its welded on side of the seat...s...
i got this heated washer jets and it seams that they are plugged with something, any ideas how to clean them to get the full spray, the left one has low spraying from only one hole and the right from both but not like they used to, stupid problem but annoying
on my car i have Bosch check control unit and i need to replace it, can i put an VDO unit i found on scrappy or it has to be Bosch,
will it work properly??
I f..... up, I bought the springs 60/40 lowering for my 320i,
BUT it turns out that the springs are for 4 cyl. models, so can i put them on my car ??? the weight is the problem on front right ???
is this easy to take off ? do i need to remove throttle body or inlet manifold or both ? i can see 2 scews that hold that throttle position sensor is that all that hold's it. is there anything to look after ? thanks PS: why is my inlet so oily from the inside and the rubber hose that goes to the fil...
Can i change the 2 blue relays on the picture (traced with red) with the orange ones like others, i'm asking couse i we seen on some others e30's that they are all orange. my car is a pre-fl 87. http://img323.imageshack.us/img323/996/fuseboxgf0.jpg blue relays http://img323.imageshack.us/img323/4741...
I got listing of equipment for my car and it says it has: 704 M SPORT SUSPENSION or in german 704 M SPORTFAHRWERK but i can't see that the car is lowered or it's too small differece to tell by the eye so i got these pictures for you guys to tell me your oppinion is this M or not i got 205/55 tyres o...
so i swapped the housing of the rear demister switch with the hazard switch (as i read that from previous posts) and added the extra wire that is needed for the illumination when i turn the lights on but it simply won't work :cry: , why? when i plug the modified demister switch to hazard socket it w...
I was wondering is it normal to rpm drops when i turn the a/c on, around 200-300 rmp in idle, i'm asking because i know that a/c equiped cars has idle increase when a/c is on, and does some1 knows how idle increse works on pre & post face lift cars (mine is a le-jet pre-facelift)