wat is the schedule of care after a cylinder head nd stem seal replacement

my bad,its an M20b20 engine,the plugs show fuel yes after cranking

js did a cylinder head gasket change,new thermostat and water pump,now the engine js cranks and doesn't fire up,i can hear the pump engaging and also checked the fuel sender line so fuel is there,also chkd for spark by jumping the plug and the ws some present,now where shud i b looking next,please a...

ok,js re did the head and fitting a new thermostat on the m20,connected all big hoses now can't seem to find where the lower nipple extension on the thermostat connects,,,,any ideas

cheers Paul greatly appreci8 the feedback mate

assistance needed,not sure if when the head was removed it was at TDC,after disassembly,schimmin nd re-assembly, now when putting the head back on,any considerations ? …or if both crank and cam pulley are lining well both at marks then its ok or war shud happen,tia!

toy

looks clean,wat did u use to clean the block surface and piston heads? nd is it a necessity to clean the piston heads or more of a cosmetic thing

toy

well it had overheated for a while while cruising on the high way without noticing and was producing a white smoke so sm advice was that its usually js better of skimming the head

thanx Paul,greatly appreciated.wl check with shop

recently did a head skim as my alternator belt slipped off the pulleys,should i use oversize gasket or just standard one