E30 Zone

can anyone recomend where i can get a new exhaust for a pre facelift 320i saloon please cheers scott.

hi, i need to replace the fuel pump on my pre facelift 320i, its located outside on the passenger side behind the sill. the one on has been replaced before and there are no numbers or markings on it, the outer casing is blue.can anyone help, there are loads listed on ebay, not sure what to go for. a...

i have been trying to fit a z3 rack today to my e30, and the bottom uj wont fit onto the z3 rack as the size of the output shaft is bigger than on the rack i took off, i am going to have to have a custom linkage of some kind.

hi, i'm looking at putting poly bushes in the front bottom arms, and i've seen eccentric ones and concentric ones, and i don't know what the difference is between them. can anyone enlighten me. cheers scott.

yes, changed the slave as well, and it just needed a bit of patience, all sorted thanks for the replies. scott

hi, i've fitted a new clutch master cylinder on my 1985 320i e30, and i am having trouble getting a decent pedal. is there any weird way or sequence of pumps needed to build up the pressure? cheers scott

hi iv'e got a 1985 320i, with a fast idle that gets faster as it warms up. iv'e traced the problem to the additional air slide valve which sits under the rear of the inlet manifold. the valve has a water feed which heats it up and operates the valve which alters the vacuum and brings the idle down. ...

so whats considered the best value for money option for an e30 engine upgrade, and whats the easiest?

hi, thanks for the replies so far, the main reason was just to be different, everyone up my way just throw a more modern engine in for power gains, and know body seems to tune the 2L engine leaving the capacity the same, there may be good reasons for not. i had a mk1 golf 20 years ago that i put a 1...

hi, can anyone point me in the direction of anyone who makes inlet manifolds for sidedraft dcoe45 carbs for a m20b20,m20b25 engine please, been looking on the net and cant find anything. might mean you cant get them, but someone here may know.cheers scott.

Whats a reasonable price to pay for a m20b25 engine, there's a couple on ebay but seem a bit expensive.

Brilliant, thanks for th ther info.

Hi, I'm converting my 320i from drums to disc's on the back, can anyone tell me if the driveshafts on my car will fit in the disc hub, im putting 325i arms and brakes on.cheers dcott

Ok, thanks for the advice

Hi,im in the middle of doing a disc brake conversion on my pre facelift 320i,I want to replace the standard bushes with poly ones, question is which ones to go for, who do you guys recommend gor them . Cheers scott

I want to convert my pre facelift e30 320i from drum brakes to discs. Do I have to change the complete arm or just brake assembly. If so will touring arms, or cabby arms fit, or cabby arms(one of each in local scrap yard), or go gor 325 setup.thsnks in advance for advice.

Ok,just read the wiki section about what csn be used,ni have had a lookb on ebay and there are lots of e46 racksnfor sale, is there any particular model thats best to use or will anyone do.

Ok, I did not know other stuff fitted, where can I grt details of e46 conversion.

Hi folks, I need some advice, I have s pre face lift 320i that does not have power dteering. My question is, is it possible to fit power steering to my car, and if so, would it be something a relative novice could dodo

I hot picd taken yesterday, but can't get them on yet, but from reading the sbove I think I eill check yhe air slide valve first and take it from there.

Ok, what info do you need to identify what I have.

Morning people, I have an 87,88 320i 4 door I am finally just about ready to put back on the road. It has sat for about 13 years in a garage, and I have replaced the fuel pump and filters etc and got it running. My question is this, when it starts it idles about 1100 rpm and as it warms up the idle ...

ah ok i kind of thought it would be something like that. worth a try, cheers.

hi, got a 87/88 e30 320i with sticking fuel gauge. car had been sitting for quite a few years and the sender was very gummed up. also one of the really small wires that runs down it inside between the terminals was broken. my question is, would i be able to replace or resolder the wire to get it wor...

hi folks i need a bit of help. finally got my 89 320i running but it was not firing on number 2 and 6. fitted new plugs and checked spark at all cylinders, which were good and strong. so i am presuming i have no fuel at the cylinder. i have just been reading the section about cleaning the injectors,...

found the problem, i had pulled out a relay on the steering column, and had not put it back in, but once plugged back in away she went. i'm not very good at all this tinkering. thanks for ant advice given.

yes the battery light went out, at the moment i have no dash lights at all, i have put a new battery on it and there is still no life at all.

what a idiot, sorry guys, it helps if i pay attention when asking questions. the car i have is a e reg 320i e30 4 door. sorry again any help appreciated.

i have a flat battery, and i jump started the car, and it ran ok. then it died and i tried to start it again, still attached to my other car, via jump leads and it was totally dead. i have checked all the fuses and nothing appears to be blown, but still, there is no life in it. is there anything els...

ok i will get it asap cheers.

i need price and availability for a rotor arm and distrbibutor cap for a e reg 320i 6 cylinder please. cheers scott

i am in perth in scotland.

i dont know if my limited mechanical skills would stretch to an engine swap, this is my first attempt at any kind of tinkering on a car!

brilliant thanks,found them and its now out of the car. cheers

afternoon, i have started stripping the seat from my 320i, and i cant for the life of me figure out how the rear seat back comes out. i cant see any bolts or fixings for it. could someone point me in the correct direction please. cheers scott.

Search found 38 matches

320i exhaust

fuel pump

Re:

lollipop bushes

Re: clutch blleding

clutch blleding

aditional air slide valve

Re: inlet manifolds

Re: inlet manifolds

inlet manifolds

325i engine

Re: disc convrrsion

disc convrrsion

Re: trailing arm bushes

trailing arm bushes

drum brakes to disc's.

Re: power steering

Re: power steering

power steering

Re: fast idle 320i

Re: fast idle 320i

fast idle 320i

Re: fuel gauge sender

fuel gauge sender

miss fire

Re: starting

Re: starting

Re: starting

starting

Re: ignition parts

ignition parts

Re: newbie

Re: newbie

Re: rear seat removal

rear seat removal